Boats For Sale:
Jabsco raw water pump impeller |
Post Reply 
|
| Author | |
Bri892001 
Grand Poobah 
Joined: September-27-2008 Location: Boston MA Status: Offline Points: 4947 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Jabsco raw water pump impellerPosted: September-21-2011 at 12:29pm |
|
The impeller is listed at the bottom of this skidim page too:
http://www.skidim.com/products.asp?dept=1096&pagenumber=1&sort_on=&sort_by= |
|
 |
|
|
Luchog
Grand Poobah
Joined: April-17-2007 Location: Argentina Status: Offline Points: 2135 |
Post Options
Thanks(0)
Quote Reply
Posted: September-21-2011 at 1:51am |
|
if you have good water pressure hose it on the trailer and give it a go see what happens. If the pump and exhaust manifolds get hot (manifolds should be hot but still touchable) you'll need to rebuild the pump. if not take it for a test ride!
|
|
|
|
|
Gary S
Grand Poobah
Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
Quote Reply
Posted: September-21-2011 at 12:10am |
|
I'm no expert but I have stayed at a holiday inn express
 West Marine shows they have them,not sure they have them in the stores but you could call, Jabsco # 1210-0001-p or 1210-0003-p or West Marine # 9507369 or 9507591. Seal # for when you rebuild it someday is 96080-0080
I have a new one or a used one if you can't find any,we'd have to find a way to get it to you- |
|
|
|
|
john b
Grand Poobah
Joined: July-06-2011 Location: lake Sweeny Status: Offline Points: 3241 |
Post Options
Thanks(0)
Quote Reply
Posted: September-20-2011 at 11:51pm |
|
I would like a little advice even though I know the proper thing to do.
I pick up my new to me 69 or 70 Mustang a week from tomorrow and it hasn't been used in several years. The current owner has had it professionally maintained (according to him) and it reportedly ran well when put away. I would really like to take it out for one ride this year and see what problems, if any, exist. I am concerned about using it without replacing the jabsco impeller, and I have no idea where to get one anyway. Is it prudent to take it out and watch the temp gauge closely? The boat is an H/M, but it has aftermarket iron Osco manifolds on it, so it can't ruin the pair of H/M manifolds I will be putting on it from another boat. The exhaust hoses could use a replacement, but I don't think they are anywhere near a rupture. Any advice from the experts? |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options