RWP Noise

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Well, heres the update.  Took apart the RWP and found nothing.  When I spin the pump by hand when apart, I can here the ticking.  Its just magnified when assembled.  It spins freely, but you can tell there something a little off with a bearing or something.  I replaced the impeller while apart and will run it till winter layup and then tear into it.  Just need to be extra cautious with the temp gauge and listen for a bang or whatever when the bearing does let go.  Good thing is we are on a private strip mine, so it wont be like were stranded in the middle of know where if that were to happen.  Any suggestions are appreciated.  Thanks

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
levinmark Members Profile Send Private Message Find Members Posts Add to Buddy List Senior Member Joined: November-11-2010 Location: illinois Status: Offline Points: 375	Post Options Post Reply Quote levinmark Report Post Thanks(0) Quote Reply Topic: RWP Noise Posted: August-29-2013 at 10:02pm
	Well, heres the update. Took apart the RWP and found nothing. When I spin the pump by hand when apart, I can here the ticking. Its just magnified when assembled. It spins freely, but you can tell there something a little off with a bearing or something. I replaced the impeller while apart and will run it till winter layup and then tear into it. Just need to be extra cautious with the temp gauge and listen for a bang or whatever when the bearing does let go. Good thing is we are on a private strip mine, so it wont be like were stranded in the middle of know where if that were to happen. Any suggestions are appreciated. Thanks
	levin

SNobsessed Members Profile Send Private Message Find Members Posts Add to Buddy List Grand Poobah Joined: October-21-2007 Location: IA Status: Offline Points: 7102	Post Options Post Reply Quote SNobsessed Report Post Thanks(0) Quote Reply Posted: August-26-2013 at 9:42am
	Take it apart - maybe you will be lucky & it is just the impeller failing.
	“Beer is proof that God loves us and wants us to be happy.” Ben Franklin

baitkiller Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Platinum Member Joined: October-11-2011 Location: SW Florida Status: Offline Points: 1693	Post Options Post Reply Quote baitkiller Report Post Thanks(0) Quote Reply Posted: August-26-2013 at 9:15am
	Might also the belt going bad. Bearings tent to growl, belts tick or slap.
	Jesus was a bare-footer.............

levinmark Members Profile Send Private Message Find Members Posts Add to Buddy List Senior Member Joined: November-11-2010 Location: illinois Status: Offline Points: 375	Post Options Post Reply Quote levinmark Report Post Thanks(0) Quote Reply Posted: August-26-2013 at 8:19am
	Good morining, 96' Ski, 351w standard that is carbed. I have a strange clicking noise coming from the RWP. When I fire up the engine and at idle it is a slow clicking and as I rev up the RPM's the clicking increases. I'm assuming this a bearing of some sort that is going bad and is going to fail any time. Looking for a little insight on this and what I need to do to repair it. Thanks Mark
	levin

RWP Noise

About CCF

Donate

Partners

Contact