Intake Manifold |
Post Reply |
Author | ||
62 wood
Grand Poobah Joined: February-19-2005 Location: NW IL Status: Offline Points: 4527 |
Post Options
Thanks(0)
Posted: November-11-2013 at 10:35am |
|
. |
||
Hollywood
Moderator Group Joined: February-04-2004 Location: Twin Lakes, WI Status: Offline Points: 13514 |
Post Options
Thanks(0)
|
|
Kind of surprised one of the guys with a H/C/I upgrade hasn't offered up a stock one for sale yet..
|
||
jacmurr
Newbie Joined: June-15-2012 Location: Sebastian, Fl Status: Offline Points: 28 |
Post Options
Thanks(0)
|
|
ah ha! I was wondering about that because so far all I can find is aluminum.
|
||
Jack's Off
|
||
Gary S
Grand Poobah Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
|
|
I pulled mine a few years ago when changing heads,it had been on for about 15 yrs in fresh water. There was some minor corrosion. You could pull your thermostat and look in,you won't see it from the outside, if you were worried. Salt,water,dissimilar metals don't mix
|
||
jblocal
Senior Member Joined: September-06-2010 Location: Stuart, Florida Status: Offline Points: 203 |
Post Options
Thanks(0)
|
|
Sorry to jump in, I have an aluminum intake on my 351w that I raw water cool in salt water. I have read some neg things on this. How concerned should I be? What I need to look for? So far it's been on there for almost 3 years and looks fine to me. I flush really good after every use and boat stays on trailer.
|
||
62 wood
Grand Poobah Joined: February-19-2005 Location: NW IL Status: Offline Points: 4527 |
Post Options
Thanks(0)
|
|
Jack,
I am parting out a 351 and have a 4 bbl stock intake available. |
||
Gary S
Grand Poobah Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
|
|
You don't have any choice seeing where you live. You'll have to go with a oem cast iron one. Any one from a 351W will work,2 or 4bbl depending on what carb you have. There are a couple on ebay right now,not as cheap as you'd think.
|
||
jacmurr
Newbie Joined: June-15-2012 Location: Sebastian, Fl Status: Offline Points: 28 |
Post Options
Thanks(0)
|
|
I got a new 351W long block for my '76 CC 210 Cuddy. Now I need a new intake manifold for it. Are the intake manifolds different on reverse rotation engine? or will any intake work? Is there a better intake available than the stock one? Where would be the best place to look?
|
||
Jack's Off
|
||
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |