Straight Boom (Barefoot International)

Greg,
Did you ever work this out?
I'm looking for a complete boom and think that I could make yours work on my 86 2001.
Let me know if you are interested in selling and how much.
Robert
914 four nine four 8747 cell

Nice work Greg. My adapter may not work you because of your tower.

Going to try this again

Will also try to upload Bills custom attachment

Not to threadjack, but Greg, I love that picture of your boat. Number 1, the boat's badass, and 2, if ever there was a happy dude standing in his new boat, that's it!

Link from a third party site, uploading directly to CCF doesn't seem to be working.

I would prefer to go with a straight boom as opposed to the countour version. I will be back up at the lake late this week and can get some additional pictures / dimensions then.

The bottom one - essentially the end is roughly 1-1/4" square with two holes drilled through all four (4) faces.

Tried again from the laptop and get a different error message - this says that the site may be under maintenance. Will need to try again later

Im sure pictures will help clear up the confusion, but I think some terms are getting mixed up here. It sounds like Adam has a BI "Straight Contour" which has a single vertical curve in it. It sounds like Greg is selling the more common "Universal Contour" which has a compound contour- it curves both up and aft... and was designed for boats that had windshields that extended further back than the pylon (late 80's and early 90's Prostars, etc).

The Universal Contour can in fact be installed backwards (so it curves up and forward) on some boats. I believe Alan had one installed this way on his '81, and I know Brad has one set up this way on his '86 2001. I would imagine a '88 could be done without much of a problem. The issue, as mentioned, is the boss where it installs in the clamp... some are only set up for one direction (rectangular boss), others are set up for both (square boss). The square boss can be drilled in 2 directions to allow it to be used on either port or stbd, or alternatively, curve forward. Brad had a rectangular boss milled and drilled... so if youve got the tools, it can be done.

I tried that too. Emailed the pic to Gregg and he was going to try uploading it later.

I will do that. tried from he pc and it wouldn't work either.

HW - will be at the lake next week and grab some pic's. The end that goes into the clamp is square and not beveled.   I have not installed on the boat but will give it a go next week. Thinking that Santa needs a barefoot pic

mine's a beveled rectangle, his may be square but I doubt it

if its like mine it goes out from the clamp, up, then out over the gunnel...and the way mine fits in the clamp you have to rotate it 180, 90 doesn't match up.

+1^

Or you can have a machine shop build an adapter for your contour. That's what I did and it works fine. It consists of a piece of aluminum pipe that fits over the round and flat part of the boom.   They then welded a piece of flat stock into that pipe at the proper angle so the contour boom is parallel to the floor. I will try to get a picture of this as it is becoming very hard to explain..