Boats For Sale:
GT-40 FCC leaking |
Post Reply 
|
| Author | |
Luchog 
Grand Poobah 
Joined: April-17-2007 Location: Argentina Status: Offline Points: 2135 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: GT-40 FCC leakingPosted: May-22-2016 at 3:47pm |
|
Since the introduction of ethanol on fuel, there has been an "upgrade" on the wiring fitting because of leaks.
|
|
 |
|
|
Mike Duffy
Newbie 
Joined: May-22-2016 Location: Colorado Status: Offline Points: 3 |
Post Options
Thanks(0)
Quote Reply
Posted: May-22-2016 at 2:41pm |
|
Thanks Gary I agree a failure with high pressure fuel in a engine compartment not a good thing. I looked at that same part but did not know if was a retrofit. My old one had a compression fit rubber part which doesn't seem like a good design, so the replacement looks like you remove the plastic and use the o ring with a nut to secure. I'll contact Nautique parts on Monday. Thanks again.
|
|
|
|
|
Gary S
Grand Poobah
Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
Quote Reply
Posted: May-22-2016 at 1:32pm |
|
I think this is what your looking for. Don't think I'd be messing with some sort of sealant with those pressures on a fuel system. Thought there was some sort of recall on them but since I dont have one didn't pay much attention.
|
|
|
|
|
Mike Duffy
Newbie
Joined: May-22-2016 Location: Colorado Status: Offline Points: 3 |
Post Options
Thanks(0)
Quote Reply
Posted: May-22-2016 at 12:53pm |
|
The plastic part on the FCC that the wiring harness goes through cracked causing a fuel leak. Does anyone have a recommendation on what type of adhesive that could be used to repair? Or a replacement for the plastic part. Thanks
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options