Boats For Sale:
3/4 hose from water pump to exhaust manifold |
Post Reply 
|
| Author | |
Irydslow 
Groupie 
Joined: April-05-2012 Location: Massachusetts Status: Offline Points: 51 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: 3/4 hose from water pump to exhaust manifoldPosted: August-05-2016 at 2:24pm |
|
I used high-temp hose from the hardware store...worked fine so far! Just moving hot water from point A to point B.
|
|
|
78 Correct Craft Southwind 20
|
|
 |
|
|
8122pbrainard
Grand Poobah 
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: August-03-2016 at 5:44pm |
|
Aaron,
You're good to go at the auto supply. Just normal heater hose works. The pressure is minimal and typically only about 4 PSI |
|
|
|
|
KooK
Senior Member 
Joined: February-10-2014 Location: Iowa Status: Offline Points: 143 |
Post Options
Thanks(0)
Quote Reply
Posted: August-03-2016 at 5:38pm |
|
1979 Mustang 17 302 4v w/ Commander exhaust manifolds.
So just a real quick question. There are 4 hoses, all 3/4 inch ID on my exhaust manifolds and they're getting a little old and need to be replaced. Where I'm at there is no boat specific parts store so I'm limited to the auto parts store or online ordering. Does this 3/4 inch hose need to be high temp and high pressure? Does it actually carry much pressure (can I use heater core hose?)? What came off it was a Goodyear Horizon 200 hose and I can't find that anywhere near me. Just looking for some suggestions on what to put back on. Thank you. |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options