Change oil |
Post Reply |
Author | |
MrMcD
Grand Poobah Joined: January-28-2014 Location: Folsom, CA Status: Offline Points: 3749 |
Post Options
Thanks(0)
Posted: October-14-2019 at 6:23pm |
I agree Pete and I admit that if my Boat only has 20 hours on it this year on my fresh oil it will probably run on that oil again next year. But if it has dirty oil change it before storing.
|
|
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
|
Yes, old oil will build up acids that can etch bearings BUT, it's time (hours) on the engine that causes the build up. Going by hours and not months is better for determining if an oil change is needed. Also, todays oils do have additives to keep the acids in check that oils way back did not have. |
|
MrMcD
Grand Poobah Joined: January-28-2014 Location: Folsom, CA Status: Offline Points: 3749 |
Post Options
Thanks(0)
|
It is better to have the engine sit on clean oil all winter. You should turn it over once clean oil is in there to distribute the clean oil through the engine. Used oil has contaminants in it that can etch an engine bearing when the boat sits for long periods.
If you are draining it with a cold engine just be patient. Open the drain hose into a bucket and leave it for a few days. Then add your new oil. It will drain, it will just take hours rather than minutes. |
|
Otto Throttle
Senior Member Joined: October-02-2017 Location: Cleveland OH Status: Offline Points: 388 |
Post Options
Thanks(0)
|
Ok good I will do the tranny today. I always change oil/filter in the spring.
Thank you! |
|
Otto
|
|
quinner
Grand Poobah Joined: October-12-2005 Location: Unknown Status: Offline Points: 5828 |
Post Options
Thanks(0)
|
Yes, takes forever, warm oil pumps or drains much better.
Trans does not matter. |
|
Otto Throttle
Senior Member Joined: October-02-2017 Location: Cleveland OH Status: Offline Points: 388 |
Post Options
Thanks(0)
|
Any real downside to doing it cold?
|
|
Otto
|
|
Otto Throttle
Senior Member Joined: October-02-2017 Location: Cleveland OH Status: Offline Points: 388 |
Post Options
Thanks(0)
|
Thank you! I know an owner who has never changed his....so in three years I have not changed mine. I just want to do it before she snuggles in to her winter slumber.
|
|
Otto
|
|
MrMcD
Grand Poobah Joined: January-28-2014 Location: Folsom, CA Status: Offline Points: 3749 |
Post Options
Thanks(0)
|
You can also run Delo or Rotella or Castrol Diesel Engine Oil, comes in 15-40.
It works fine in flat tappet engines. ( standard Lifters, not Rollers ) It is about 1/2 the cost of the fancy oils but works and is available everywhere, like Walmart. For a Filter both Wix and Hastings offer good high quality filters. Wix is available at all Napa Parts Stores. |
|
Hollywood
Moderator Group Joined: February-04-2004 Location: Twin Lakes, WI Status: Offline Points: 13514 |
Post Options
Thanks(0)
|
The Topsider is a POS get the mityvac
|
|
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
|
Engine AND trans:
|
|
KENO
Grand Poobah Joined: June-06-2004 Location: United States Status: Offline Points: 11093 |
Post Options
Thanks(0)
|
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
|
It's sucked. |
|
Otto Throttle
Senior Member Joined: October-02-2017 Location: Cleveland OH Status: Offline Points: 388 |
Post Options
Thanks(0)
|
How do you get the fluid out of your tranny?
Thanks |
|
Otto
|
|
Stuckers Nautique
Newbie Joined: September-08-2019 Location: Devils lake MI Status: Offline Points: 30 |
Post Options
Thanks(0)
|
Thanks
|
|
Jonny Quest
Grand Poobah Joined: August-20-2013 Location: Utah--via Texas Status: Offline Points: 2974 |
Post Options
Thanks(0)
|
Most will recommend Dextron III. I use a fully synthetic that is Dextron III compatible. Some will say that the fully synthetic is too "slick" and that one should stick with the Dextron III. No issues with my rig with the full synthetic after several years of use. I use the Royal Purple MAX ATF. The PCM 1.23:1 tranny takes 2 quarts.
JQ (your mileage may vary) |
|
Current
2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
|
Stuckers Nautique
Newbie Joined: September-08-2019 Location: Devils lake MI Status: Offline Points: 30 |
Post Options
Thanks(0)
|
OK thanks what type of transmission oil would you recommend then
|
|
Jonny Quest
Grand Poobah Joined: August-20-2013 Location: Utah--via Texas Status: Offline Points: 2974 |
Post Options
Thanks(0)
|
What I use:
Filter K&N 3001 Oil Mobil 1 15W-50 Valvoline VR-1 20W-50 (full. Synthetic) Royal Purple HPS 20W-50 Need ZDDP “zinc” level 1,200+ ppm (for flat tappet cam) I do a full fluid change (engine & transmission) at the end of each season for a cold lay-up. JQ |
|
Current
2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
|
Stuckers Nautique
Newbie Joined: September-08-2019 Location: Devils lake MI Status: Offline Points: 30 |
Post Options
Thanks(0)
|
I am new to the boating I have a 1994 sport Nautique with a 351 wondering what type of oil to use it and if it be a good idea to use a better type of oil.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |