Boats For Sale:
Switch breakers |
Post Reply 
|
| Author | ||
Klundog 
Newbie 
Joined: March-22-2017 Location: North Bay Area Status: Offline Points: 13 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Switch breakersPosted: August-20-2020 at 12:01pm |
|
|
Thank you JQ for the reply. I borrowed an accessory to get the Nav lights going
I thing I will purchase two replacement 10, a back up 20
|
||
|
Klundog
"Boats, vessels of freedom!" |
||
 |
||
|
Jonny Quest
Grand Poobah 
Joined: August-20-2013 Location: Utah--via Texas Status: Online Points: 2979 |
Post Options
Thanks(0)
Quote Reply
Posted: August-19-2020 at 10:07pm |
|
|
2.5 Amp Bilge pump / auto bilge pump (8.0 Amp for Barefoot Nautique)
6.0 Amp Blower 10 Amp Nav lights / anchor lights 10 Amp Accessory 20 Amp Ignition The above Push-to-Release / Reset breakers were on my 1994 Ski Nautique. JQ
|
||
|
Current
2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
||
|
||
|
Klundog
Newbie
Joined: March-22-2017 Location: North Bay Area Status: Offline Points: 13 |
Post Options
Thanks(0)
Quote Reply
Posted: August-19-2020 at 12:57pm |
|
|
Is there a source for a complete set?
I have accessory switches as well but do not know the AMP. I suppose I can remove and check them. Related I added a tower light and wired to the navigation switch. Shortly later, switch went bad. I suppose I should wire the tower navigation light to one of the accessory switches. Where is the best point of location to wire? seems like the switch is a hap-hazard way of doing it
|
||
|
Klundog
"Boats, vessels of freedom!" |
||
|
||
|
Nauti Gator
Groupie 
Joined: August-01-2016 Location: Florida Status: Offline Points: 62 |
Post Options
Thanks(0)
Quote Reply
Posted: July-07-2020 at 12:48am |
|
Thanks for the clarification - I'd rather be known as a classic than an antique 
|
||
|
||
|
ultrarunner
Platinum Member 
Joined: October-02-2005 Location: Ridgefield, Ct. Status: Offline Points: 1846 |
Post Options
Thanks(0)
Quote Reply
Posted: July-06-2020 at 11:22pm |
|
|
Sounds like a good fall project and swap the all out. Thanks.
Ultra. |
||
|
||
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: July-06-2020 at 10:27pm |
|
Mike, Just a friendly FYI, boats aren't classified like other items like autos. The "antique" class is pre WWII. After the war boats are in the "classic" category. |
||
|
||
|
Nauti Gator
Groupie
Joined: August-01-2016 Location: Florida Status: Offline Points: 62 |
Post Options
Thanks(0)
Quote Reply
Posted: July-06-2020 at 10:17pm |
|
The ETA circuit breakers were originally installed in my '93 Sport. I just replaced all of them at the same time with new ETA's. Just check the amp rating of each because they are not all the same. Both skidim and nautique parts have them. nautique parts lists the common amp ratings for each breaker depending on the use. I had to buy two from an electric parts house because I couldn't find the same amp rating as what I needed. If one is going bad I would just replace them all. My boat is almost an antique! |
||
|
||
|
ultrarunner
Platinum Member
Joined: October-02-2005 Location: Ridgefield, Ct. Status: Offline Points: 1846 |
Post Options
Thanks(0)
Quote Reply
Posted: July-06-2020 at 9:42pm |
|
|
Hey gang, I have a nav light switch that is intermittent. Wiring looks good. are the eta switches on skidim a good replacement?
|
||
|
||
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
8122pbrainard wrote: