Boats For Sale:
1986 Correct Craft Martinique Shaft Seal |
Post Reply 
|
| Author | |
KENO 
Grand Poobah 
Joined: June-06-2004 Location: United States Status: Offline Points: 11155 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: 1986 Correct Craft Martinique Shaft SealPosted: July-30-2021 at 6:15pm |
|
If it's looking awfully weak, you might as well do it now instead of later, otherwise it makes for a big hard to stop leak when it decides to let go.
|
|
 |
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: July-30-2021 at 4:57pm |
Never a bad idea but, you need to pull the shaft and with a single taper shaft, that can be a job.
|
|
|
|
|
stm1258
Newbie 
Joined: August-14-2012 Location: Sterling VA Status: Offline Points: 14 |
Post Options
Thanks(0)
Quote Reply
Posted: July-30-2021 at 11:29am |
|
So quick question....what about that rubber hose piece below the coupling where the shaft goes out the boat. That has never been changed and is looking awfully weak.
Thanks!
|
|
|
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: July-30-2021 at 7:36am |
|
Sean,
Unless you have a "dripless" prop shaft seal, the seal is actually a rope seal inside the packing gland where the shaft enters the bilge. Is your's leaking? It should drip some since the rope packing is water lubricated. Take a look: Here's a better video on an actual prop shaft: |
|
|
|
|
stm1258
Newbie
Joined: August-14-2012 Location: Sterling VA Status: Offline Points: 14 |
Post Options
Thanks(0)
Quote Reply
Posted: July-30-2021 at 7:22am |
|
Hi Gang,
You all have been amazing! Thank you. So the two problems I posted before have been solved. Windshield broken on left side...local glass shopped fixed it for me for $121.00 and the distributor has been replaced. Thank you all. So I have never replaced the shaft seal. I am looking to order one. I am guess that size is a 1" shaft seal. Believe it or not I have the original one on there. Thanks Gang, -Sean
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
stm1258 wrote: