stereo installs........ |
Post Reply | Page 123 6> |
Author | |
dans
Senior Member Joined: March-23-2006 Location: United States Status: Offline Points: 187 |
Post Options
Thanks(0)
Posted: March-04-2007 at 9:12pm |
Herculiner. I used the roll on kit. This brand works , I have it on the trailer & my Jeep wrangler inside.
|
|
bkhallpass
Grand Poobah Joined: March-29-2005 Location: United States Status: Offline Points: 4723 |
Post Options
Thanks(0)
|
Dan,
Did you use rhino liner on the dash?? BKH |
|
Livin' the Dream
|
|
dans
Senior Member Joined: March-23-2006 Location: United States Status: Offline Points: 187 |
Post Options
Thanks(0)
|
Well my dask black top part needed paint so I put the CD inside the dash & a cup holder .I dont care if I gotta buy a CD player every time it gets wet.I got tierd of reaching under the dash.
|
|
Guests
Guest |
Post Options
Thanks(0)
|
no,thank you.....glad it workd for ya.....
|
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
Soldered wires to the board of the Audiobahn powered sub. This thing hits a lot better than my 8" bazooka. takes up a lot more space under the observers seat. I want to build a sub into the kick panel under the helm eventually. This will work for now.
Thanks Ryan! |
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
ahh, i see now.
|
|
Guests
Guest |
Post Options
Thanks(0)
|
randy the wire is called thnn or thhn look on the wire....i guess that and one other type of wire is actually approved for marine use...a great thing, let me know if you personally ever need any wire etc.later
|
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
had to pry at it with a putty knife. It came apart...
|
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
dans, so you got yours apart? maybe I will try again. seemed like it was glued in there real good and I didn't want to break anything. I'll try again...
|
|
dans
Senior Member Joined: March-23-2006 Location: United States Status: Offline Points: 187 |
Post Options
Thanks(0)
|
Do you have an Audiobahn 10 inch tube ? I have two of those .One in wifes Jeep & one in my truck. Both harnesses broke .The harnesses to these suck.I unscrewed the back , pryed out the amp, soldered ground to black wire ,power to red wire(duh) & tested on a battery in the house .Then touched the remote wire to solder parts on the board until the on light came on.Then soldered the remote wire in. Ran wired through old harness holes. My box in my boat is Herculined. Making it waterproof & ba$$ hard . $ 29.00 for a small can & roll on .Works good . I just did my trailer in Herculiner. $89.00 for the big can kit . I gotta put up some pics soon, this stuff is incredible .Dan
|
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
The equipment is all connected directly to batt.#2. It doesn't matter which way you switch the switch the stuff is still connected directly to the battery. The switch serves to isolate the starting battery so that even if you drain batt.#2 completely you can still start the boat with batt.#1. You will probably want to keep it set to ALL most of the time so both battery's are being charged by the alternator. If you are out at the sand bar drinking beer and pounding the ba$$ you would probably want to switch it to battery #2 to keep battery #1 from draining. Then before starting the boat switch to battery #1 and once started switch to ALL so you are charging both battery's.
I tried to take the Audiobahn apart to solder leads to the board for power, remote and ground. Apparently everything is glued before it is screwed together because it is not coming apart... I guess I will call Audiobahn tomorrow and order the wiring harness. |
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
Are you saying it is thin? That doesn't make sense... it's not thin, a little stiff though. |
|
Guests
Guest |
Post Options
Thanks(0)
|
hooking up that audiobahn???? getting the fever ehh..lol...no big deal, i trust you..just got al ilttle confused, ithought that when i turned it to #1 i would have no power....tried injecting the zerk fitting with some grease yet?....i was reading on planet nautique a minute ago, and that wire we have is thnn if you look...i guess thats the best wire for marine use....its the only wire approved by a few different marine companies..thats cool to hear, is a bitch to work with though.....have fun
|
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
Everything is good, it is working like it should. Give me a call if you want me to explain it to you. I'll be out in the garage messing on the boat for a couple hours yet.
|
|
Guests
Guest |
Post Options
Thanks(0)
|
not a big deal randy, either way im pressing a button, wether its a breaker or my cd player....correct?....i was just confused today cause i was toying around and noticed i could get power out of #1 #2 all ...wanted to make sure all was good before i tied it all up put it all back together....thanks
|
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
I quoted the Dr. because he explained it perfectly earlier. The switch controls which battery is powering the starter and the rest of the boat. while running, If you have it set to #1 you will be charging the #1 battery. If set to #2 you will be charging the #2 battery. if set to ALL it will be charging BOTH battery's. The stereo equipment is wired to the blue battery with the screw down terminals (I think that is #2...) You should use it just how the dr. described it. I confirmed how to connect it to the Aux. breaker by looking at mine today. Just how i thought... if you want to run it through the aux switch let me know. |
|
Guests
Guest |
Post Options
Thanks(0)
|
thanks bkh-again as randy will soon chime in im a complete idiot to this stuff, but learning. can honestly say this sites pretty damn cool and very damn useful...thanks, ryan
|
|
bkhallpass
Grand Poobah Joined: March-29-2005 Location: United States Status: Offline Points: 4723 |
Post Options
Thanks(0)
|
Ryan,
I have a perko in mine. I don't know whether it is or isn't hooked up properly. However, I will say that the stereo will play whether set on 1,2, or all. I was told that if I was going to sit for along period of time with the stereo playing, to set it on 2. I was told that current would not be drawn from Battery 1. This way, even if I ran battery 2 down, I would be able to start the boat from battery 1. BKH |
|
Livin' the Dream
|
|
Guests
Guest |
Post Options
Thanks(0)
|
randy- was playing around today(sunday) with the stereo and noticed something good and bad...good part everything is still working and i moved the sub all the way uo facing towards the back.. turned the gain up a few hairs and holy sh*t does it pound..everything up front shakes and everything that doesnt shake vibrates...if i turn it up past 24-25 on my cd player it starts to skip....sounds freaking awesome, pretty amazing for one 12" sub and 4 speakers in a boat...ok so bad news is this....you know how the perko has a 1-2-all-off switch...well battery #2 was supposed to be for the stereo only, one for starting...well if i turn the knob to 32 it plays, and it also plays on #2 and all...the whole idea is to have the battery for instance #1 as the "boat starting battery"...shouldnt play while turned to one..correct or im i confused, which could very will be...i just want to make sure one battery is not getting any amp/volts used...should it still play while turned to all?.(it does)and should it still play while turned to #1(it does)
|
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
I was thinking something like this:
Or some type of battery terminals... We can figure it out Saturday and send someone to the store if needed... |
|
Guests
Guest |
Post Options
Thanks(0)
|
randy talked to eric today. sqaturday should be fine..eric mentinoed something around 800am?. too early, if so no big deal....beers cracked by 900am! i got the ring terminals for 8 gauge wire? is this what i need? or do i need them for the 3 gauge wire?.anyways i have 8 ring terminals for 8 gauge wire and 4 ring terminals for 2 gauge(will have to crimp if needed).hope i have the right ones, your not talking about like the ones on my car battery or boat are you?..those big heavy ones?...eric said to call me friday to get final details..time beer choice etc..anything else you can think of?
|
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
Ryan, check with Lowes on the speaker wire. If you don't have a lowes near you let me know, I have a lowes about a half mile from me.
That amp looks fine. I had to get really close to the screen to see them but it has speaker level inputs the are the two white rectangular plugs on the upper right hand corners. they must come with some type of wire harness. |
|
Guests
Guest |
Post Options
Thanks(0)
|
home depot wanted 60 for 100 ft of 14 gauge wire!
|
|
Guests
Guest |
Post Options
Thanks(0)
|
randy go to audio allies.com, click on marine audio go to the maa465 amp...it shows both sides of the amp(4 channel)..i see it has 2 sets of line ins, 2 red/white plugs for rcas?.is this going to be what i need?...
|
|
Guests
Guest |
Post Options
Thanks(0)
|
randy -the amp is a bazooka maa465...www.sonicelectronix.com
|
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
SkiPA- did you get a chance to send that out yet?
|
|
Randy_in_Ohio
Platinum Member Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
|
Ryan, this weekend should be fine. do you have everything we are going to need? What time are we going to start? I think we should try to get an early start. looking forward to meeting you and Eric.
|
|
Guests
Guest |
Post Options
Thanks(0)
|
randy- do you still feeel like installing this weekend?..saturday the 24th// i will try to contact eric to see if hes available(shop)..eric if you see this please let me know so we can schedule a time/place to install the stereo equipment in my boat..thanks ryan
|
|
Guests
Guest |
Post Options
Thanks(0)
|
ski anyway i could give you some cash chrcl money order for 75 feet of 14 gauge?..if not ill just purchase off ebay...
|
|
SKI79PA
Groupie Joined: July-03-2006 Location: United States Status: Offline Points: 36 |
Post Options
Thanks(0)
|
Randy,
I am sorry i have been really busy. I will ship out that wire tomorro to u usps. We have been snow in for a few days. |
|
Post Reply | Page 123 6> |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |