Boats For Sale:
Pressure Plate |
Post Reply 
|
| Author | |
zachjeepyj 
Newbie 
Joined: June-06-2009 Status: Offline Points: 20 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Pressure PlatePosted: June-29-2009 at 6:11pm |
|
Im not sure what u call it but the plate that bolts to the flywheel.Could this this cause slippage mine appears to be busted.Thanks Zach
|
|
 |
|
|
8122pbrainard
Grand Poobah 
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: June-29-2009 at 6:30pm |
|
Zach,
You're correct that it's not a pressure plate because you don't have a clutch. It's a dampner plate. I doubt it's the cause of your trans slipping but still a good idea to change out. If all the springs were busted out or the splines in the output hub were gone then you wouldn't get anything into the trans. What trans do you have? |
|
|
|
|
zachjeepyj
Newbie
Joined: June-06-2009 Status: Offline Points: 20 |
Post Options
Thanks(0)
Quote Reply
Posted: June-29-2009 at 10:14pm |
|
Borg Warner
|
|
|
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: June-29-2009 at 11:20pm |
|
Zach,
Here's the Sach's plate for the Velvet drive. It's the trans input shaft spline that is key to the correct plate. You'll notice there are 7 different hole patterns for bolting up to almost any engine's flywheel. 
And here's a source merequipment |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options