Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - Spindle Replacement??
  FAQ FAQ  Forum Search   Register Register  Login Login

Spindle Replacement??

 Post Reply Post Reply Page    <12
Author
81nautique View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: September-03-2005
Location: Big Rock, Il
Status: Offline
Points: 5779
Post Options Post Options   Thanks (0) Thanks(0)   Quote 81nautique Quote  Post ReplyReply Direct Link To This Post Posted: March-23-2010 at 10:39am
Originally posted by Gary S Gary S wrote:

I have them but have not taken them apart to see how they look. Part #1 in the pic is cup shaped to fit over the old seal surface.Then the oring goes on between that part and the bearing to seal the spindle to that cup. Then the oversize seal runs on the outside of the cup. You put pressure on the bearing buddy and the oring just keeps the grease from going out between the spindle and where the cup meet.All but one size is under $13 one is 21. I think it's worth a try, if it works great,alot cheaper than having a spindle replaced only to rust out again.


I have a set of these on my 81 trailer, 2 years, lots of road miles and they've never leaked. The seal is the same design as original, just sized to go over the sleeve. The sleeve itself has a simple O ring and seems to work fine. You might be able to force grease out of the seals if you over fill the bearing buddy with a grease gun but you will do that with just about any seal.
You can’t change the wind but you can adjust your sails
Back to Top
 Post Reply Post Reply Page    <12
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2024 | Bagley Productions, LLC