Ford motor Parts!

Sorry Sam no it was not a cam and lifter set just the cam.
I got it from Northern Auto on a close out when Crane went out of busines. I am selling it for what I paid for it.
Thanks.

Jody

http://www.autoweek.com/article/20090225/carnews/902259979

I was shocked to when i read that Crane had gone out of business how ever they may have been bought out and are back in business. Like I said this was a close out from Norther Auto parts a little more than a year ago. $140.00 plus shipping, best I can do!

Jody

Old Ford Stock liquidation New and used Parts. 351-w/GT-40
1.     Pair GT-40 heads re-conditioned complete w/brass freeze plugs
        $400.00    "SOLD"
2.     Pair Gt-40 Heads Re-conditioned complete $500.00 "SOLD"
3.     Pair Standard HP heads re-conditioned complete $300.00 "SOLD"
4.     Cast Iron 4BBL intake manifold $35.00 "SOLD"
5.     8, .30 over hyperputic pistons 9.0:1 on sized rods $200.00
6.     Right hand performance ground cam shaft with lifters 1 hr run
        time $200.00 "SOLD"
7.     Edelbrock intake manifold used/bead blasted $100.00 "SOLD"
8.     Right hand crankshaft $100.00 1 piece seal
9.     Left hand crank shaft $100.00 1 piece seal
10.     Bell housing $75.00
11.     New bell housing $200.00
12.     2 sets of pully’s $35.00 per set (upper and lower)
13.     3 harmonic balalncer’s $20 ea
14.     R139006 Gear, starter ring 157 teeth “new” $98.00
15.     Flywheel complete with new starter ring gear $145.00
16.      2 used Fly wheels $25 ea
17.     3 timing chain covers “NLA” from PCM $100.00 ea
18.     2 complete upper/lower thermostat housings $40.00 ea
19.     1 J-tube with new hoses and clamps $40.00
20.     1 “Chrome” upper thermostat housing $75.00   "SOLD"
21.     2 sets reduction motor mounts $20.00 per set
22.     Many misc throttle brackets and engine hardware.

Geting out of the Ford Business everything will go, make me a decent offer and you might be suprised what you can get!      

Jody, I sent you an offer for the heads and intake.

NC_Tique wrote: Email Sent

Yes you did but you left no way of getting back to you. Both cams are available and are flat tappet.

Jody,

Do you have any Ford FE parts by chance?

Darn. You wouldn't be interested in a Velvet Drive with only 10 hours on it with a bellhousing and damper for a 350 would ya?

Doc, it's open to anyone and posted on the parts site. Peddlin my stuff just like Jody. So first come first served. I need to move it and I have a good price on it for a 10 hour tranny.

I would need a number for ya Billy

Thanks for letting everyone know it's open Jody.

I have a nice set of GT-40 heads that have been re-conditioned.

Also a complete pull out Bob tail 5.0/HO EFI Chevy Motor ready to drop in where the Ford went. It came out of a 2001 SN (year model). Very Nice motor.