Boats For Sale:
2002 SAN warning light |
Post Reply 
|
| Author | |
timhorr 
Newbie 
Joined: July-22-2015 Location: austin Status: Offline Points: 4 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: 2002 SAN warning lightPosted: September-22-2015 at 1:14pm |
|
the warning light above the starter combination pad keeps blinking and beeping. says don't operate over 1200 RPM. i topped of engine oil (10w40), v-drive fluid (30 weight), and transmission fluid was fine....why would i be getting the warning that wont stop??? Someone mentioned replacing the replacing the Pressure sensor with a 4psi hobbs switch available at NAPA. NAPA asked if the pressure sensor is "normally closed" or "normally open"...I believe the engine is the PCM 350...any advise? thoughts? |
|
 |
|
|
MI-nick
Gold Member 
Joined: January-12-2009 Location: Ypsilanti, MI Status: Offline Points: 810 |
Post Options
Thanks(0)
Quote Reply
Posted: September-25-2015 at 2:56pm |
|
does it stay on OVER 1200 RPM's? I believe the warning says something like "don't operate if light stays on above 1200RPM's"...the sensor is checking for oil in the V-drive...if it goes off OVER 1200RPM's, you have no issue...
|
|
|
As far as I can tell, I'm not quite sure...
|
|
|
|
|
quinner
Grand Poobah 
Joined: October-12-2005 Location: Unknown Status: Offline Points: 5828 |
Post Options
Thanks(0)
Quote Reply
Posted: September-25-2015 at 3:01pm |
|
And if you have an Excalibur GM350 (330hp with silver shroud), check your manual, you should likely be running 15W-40 oil, if it is a Ford 351 GT-40 then an entirely different oil.
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options