Boats For Sale:
help identify parts please |
Post Reply 
|
| Author | |
74Wind 
Grand Poobah 
Joined: August-02-2011 Location: Georgia Status: Offline Points: 2101 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: help identify parts pleasePosted: July-23-2018 at 3:51pm |
|
74 351 T-E.
Starts/runs well, gets a bit boggy maybe 45 minutes in, but never dies. Hasn't had much use, been running out the old gas, visually tank looks clean, but sure it's due for fuel filter, might as well ask about other potential culprits while here: Can anyone identify below fuel filter, coil and valve and advise a source, and replacement process? (or any other ideas..) Thanks     
|
|
|
1974 Southwind 18
1975 Century Mark II |
|
 |
|
|
gun-driver
Grand Poobah
Joined: July-18-2008 Location: Pittsburgh, Pa Status: Offline Points: 4127 |
Post Options
Thanks(0)
Quote Reply
Posted: July-23-2018 at 4:19pm |
|
Valve covers are after market painted blue instead of original black, I have a set I’d sell if anyone is interested.
Coil is either resisted or not can check how it’s wired through the ballast resistor or use a meter. Can’t help ya on the filter. |
|
|
|
|
Gary S
Grand Poobah
Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
Quote Reply
Posted: July-23-2018 at 5:34pm |
|
Filter you remove by turning counter clockwise it has an replaceable element inside, don’t damage the housing, you can still get them but not easy. You can use a Fram CG 20 or whatever brand you like that cross references. Make sure there is a new gasket in the box when you purchase it. GF 157 in AC filters
|
|
|
|
|
gun-driver
Grand Poobah
Joined: July-18-2008 Location: Pittsburgh, Pa Status: Offline Points: 4127 |
Post Options
Thanks(0)
Quote Reply
Posted: July-24-2018 at 9:45pm |
|
OOPS sorry thought you meant valve covers but I see you mean the anti-syphon valve assuming the one with the braided fuel line, looks like it could be this
https://www.skidim.com/ELBOW-3_8-INV-FLARE-X-1_4-NPT/productinfo/R024017/ The straight one I would think is your vent and would just be a barb fitting for 5/8 vent tubing |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options