Rub rail insert |
Post Reply |
Author | |
Wilhelm Hertzog
Senior Member Joined: June-14-2014 Location: Cape Town Status: Offline Points: 349 |
Post Options
Thanks(0)
Posted: March-10-2022 at 1:11am |
My boat's rope rub rail has been replaced with an aftermarket vinyl insert style rail. This insert pops out at the mere suggestion of a dock pole rubbing against it or a swimmer sliding into the water over a gunwale, leaving things looking like this:
I did notice that the ends of the rub rail do not have a/an end cap(s) fitted: I'm thinking that the lack of end cap means the insert is not pulled tight enough into the rail, which results in the insert popping out so easily. Am I on the right track with my thinking? Will removing the insert, heating it up, stretching it tight around the boat when re-inserting and then fitting an end cap to keep it tensioned perhaps solve my problem? Or am I on the wrong track here? |
|
1982 Ski Nautique PCM351W RR II Velvet Drive 10-17-003 1:1 II PerfectPass Stargazer
Do not go gentle into that good night. Rage, rage against the dying of the light. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |