Boats For Sale:
Transmission Leak thru shift lever input |
Post Reply 
|
| Author | |
Tom351 
Groupie 
Joined: August-23-2010 Location: Chapel Hill, NC Status: Offline Points: 98 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Transmission Leak thru shift lever inputPosted: October-23-2010 at 2:57pm |
|
The transmission on my 1986 SN (351/1:1) has a decent leak through the point where the shift lever goes into the transmission case- I have never done any transmission work so this is my question?
How easy/difficult is it to remove the shift lever shaft (or whatever it is called) and replace the seal at this location? |
|
 |
|
|
skfitz
Senior Member 
Joined: October-15-2009 Location: Herculaneum Status: Offline Points: 138 |
Post Options
Thanks(0)
Quote Reply
Posted: October-24-2010 at 8:14pm |
|
4804H
Sounds like the "O" ring that has failed. The O ring's factory part number is 4804H. You might get away with just replacing it (1/2 banana job),* but if it failed there is probably a reason for the failure, like pitting of the seal surfaces, etc. * See p. 24 of this: http://www.correctcraftfan.com/Downloads/Velvet_Service_Manual.pdf |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options