Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - Siezed GT40
  FAQ FAQ  Forum Search   Register Register  Login Login

Siezed GT40

 Post Reply Post Reply Page    <1 345
Author
Silver15 View Drop Down
Senior Member
Senior Member
Avatar

Joined: March-24-2010
Location: Orlando Fl
Status: Offline
Points: 398
Post Options Post Options   Thanks (0) Thanks(0)   Quote Silver15 Quote  Post ReplyReply Direct Link To This Post Posted: August-02-2012 at 1:38am
Gordon, we stuck some white copy paper down there hoping to locate where it is leaking from. We ran it under load, but no faster than about 20kts. We saw no leaks. It's the weirdest thing. Then again, when the issue began to arise, we were at skiing speeds. Are there any common problems associated with these symptoms?
Thanks. Jake.
2000 Air/Sport
1978 T16

Back to Top
Gary S View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: November-30-2006
Location: Illinois
Status: Offline
Points: 14096
Post Options Post Options   Thanks (0) Thanks(0)   Quote Gary S Quote  Post ReplyReply Direct Link To This Post Posted: August-02-2012 at 1:47am
Originally posted by Gary S Gary S wrote:

input shaft on the trans could be rusty too. Don't ask how I know



Hey Jake remember my post in the begining of this thread??? I know you have a different trans but due to the conditions that yours and mine were kept in I'll bet the end results were the same,alot of oil in the boat!. The input shaft of the trans rusted and when running tore up the seal.Mine had pitting too so I used a Speedi Sleeve to fix it. So pull your trans and take a look.
69 Mustang HM SS
95 Nautique Super Sport
Back to Top
Silver15 View Drop Down
Senior Member
Senior Member
Avatar

Joined: March-24-2010
Location: Orlando Fl
Status: Offline
Points: 398
Post Options Post Options   Thanks (0) Thanks(0)   Quote Silver15 Quote  Post ReplyReply Direct Link To This Post Posted: August-02-2012 at 2:26am
Gary, I did notice your post from earlier and considered it. It definitely sounds like it could potentially be the culprit. The '86 I had came out of the same type of situation and needed a front end seal after a few weeks too. Go figure. I bet you're right on with that one. How difficult was it to change the seal? Never done it myself. The dampner should probably be replaced while it's apart, also. Well, crap. I wanted to ski some more this summer.

Thanks, Jake.
2000 Air/Sport
1978 T16

Back to Top
Gary S View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: November-30-2006
Location: Illinois
Status: Offline
Points: 14096
Post Options Post Options   Thanks (0) Thanks(0)   Quote Gary S Quote  Post ReplyReply Direct Link To This Post Posted: August-02-2012 at 2:39am
Not hard at all,the hardest is installing the speedi sleeve if needed and of course pulling it out.Napa has the sleeves
69 Mustang HM SS
95 Nautique Super Sport
Back to Top
Silver15 View Drop Down
Senior Member
Senior Member
Avatar

Joined: March-24-2010
Location: Orlando Fl
Status: Offline
Points: 398
Post Options Post Options   Thanks (0) Thanks(0)   Quote Silver15 Quote  Post ReplyReply Direct Link To This Post Posted: August-02-2012 at 10:18pm
Good to hear. Napa is right around the corner. I am anticipating the tranny removal to be lots of fun as it was on the barracuda. Confused, went down again today to check and see where it was leaking from, and still no obvious signs of leakage anywhere!
Thanks for all input.
Jake.
2000 Air/Sport
1978 T16

Back to Top
Dreaming View Drop Down
Platinum Member
Platinum Member
Avatar

Joined: May-21-2010
Location: Tacoma, WA
Status: Offline
Points: 1870
Post Options Post Options   Thanks (0) Thanks(0)   Quote Dreaming Quote  Post ReplyReply Direct Link To This Post Posted: August-03-2012 at 1:44am
mine was leaking from the shift lever... pretty quick O ring replacement if I remember correctly.   you might check there also :)
Back to Top
Silver15 View Drop Down
Senior Member
Senior Member
Avatar

Joined: March-24-2010
Location: Orlando Fl
Status: Offline
Points: 398
Post Options Post Options   Thanks (0) Thanks(0)   Quote Silver15 Quote  Post ReplyReply Direct Link To This Post Posted: August-03-2012 at 2:44am
Checked with copy paper again before going out and found fresh drips on the bottom of the tranny underneath the interface between the engine and tranny. Must be that front seal on the input shaft. Dreaming, thanks, and I did be sure to check that; anything not to pull the tranny lol. Seems fine. I'm very tempted to lay out some bildge diapers under the tranny, keep it topped off, and let it slide until the end of season and mess with it this winter. Anybody think this could damage the tranny? I am aware, this is majorly shadetree.
Thanks, Jake.
2000 Air/Sport
1978 T16

Back to Top
8122pbrainard View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: September-14-2006
Location: Three Lakes Wi.
Status: Offline
Points: 41040
Post Options Post Options   Thanks (0) Thanks(0)   Quote 8122pbrainard Quote  Post ReplyReply Direct Link To This Post Posted: August-03-2012 at 8:36am
Jake,
The leak will not hurt the trans as long as you keep it topped off. If it is the input shaft seal, understand that there may be other internal problems with the trans.


54 Atom


77 Tique

64 X55 Dunphy

Keep it original, Pete
<
Back to Top
Silver15 View Drop Down
Senior Member
Senior Member
Avatar

Joined: March-24-2010
Location: Orlando Fl
Status: Offline
Points: 398
Post Options Post Options   Thanks (0) Thanks(0)   Quote Silver15 Quote  Post ReplyReply Direct Link To This Post Posted: August-03-2012 at 10:11pm
What internal problems would you anticipate? I'm a little new to the transmission interworkings.
Thanks, Jake.
2000 Air/Sport
1978 T16

Back to Top
8122pbrainard View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: September-14-2006
Location: Three Lakes Wi.
Status: Offline
Points: 41040
Post Options Post Options   Thanks (0) Thanks(0)   Quote 8122pbrainard Quote  Post ReplyReply Direct Link To This Post Posted: August-03-2012 at 10:18pm
Originally posted by Silver15 Silver15 wrote:

What internal problems would you anticipate? I'm a little new to the transmission interworkings.
Thanks, Jake.

Worn pump clearances allowing oil to bypass the normal O ring seal. Since you are "new to transmission inter workings". I highly suggest you do not undertake a rebuild yourself.


54 Atom


77 Tique

64 X55 Dunphy

Keep it original, Pete
<
Back to Top
Silver15 View Drop Down
Senior Member
Senior Member
Avatar

Joined: March-24-2010
Location: Orlando Fl
Status: Offline
Points: 398
Post Options Post Options   Thanks (0) Thanks(0)   Quote Silver15 Quote  Post ReplyReply Direct Link To This Post Posted: August-04-2012 at 1:18am
Don't worry, Pete. I definitely wasn't about to try. (Although, I guess I need to learn at some point). I think I can manage the seal, though, hopefully.
2000 Air/Sport
1978 T16

Back to Top
 Post Reply Post Reply Page    <1 345
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2024 | Bagley Productions, LLC