Boats For Sale:
Velvet drive |
Post Reply 
|
| Author | |
Tom85 
Newbie 
Joined: July-04-2021 Location: Michigan Status: Offline Points: 7 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Velvet drivePosted: July-05-2021 at 9:40am |
|
I was running across the lake yesterday with no problems and out of nowhere the boat just stopped and engine revved up. I placed shifter in neutral and tried to put it back in fwd and could hear knocking. It did not go in fwd Back to neutral and the knocking was still there. Boat will not go in any gear now. It knocks from transmission area and the output shaft moves slightly on and off while engine is running Any thoughts? |
|
 |
|
|
8122pbrainard
Grand Poobah 
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: July-05-2021 at 9:59am |
|
Tom,
I'd say the trans is fine but the damper plate isn't. Pulling the bell housing and trans will confirm. Welome to CCfan. What boat is it?
|
|
|
|
|
Tom85
Newbie
Joined: July-04-2021 Location: Michigan Status: Offline Points: 7 |
Post Options
Thanks(0)
Quote Reply
Posted: July-05-2021 at 10:52am |
|
It’s in a 1986 correct craft martinique. Trans was rebuilt in 2016.
|
|
|
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: July-05-2021 at 10:54am |
Was a new damper installed when the trans was done? For around $100, it's always a good move.
|
|
|
|
|
Tom85
Newbie
Joined: July-04-2021 Location: Michigan Status: Offline Points: 7 |
Post Options
Thanks(0)
Quote Reply
Posted: July-05-2021 at 11:14am |
|
I don’t see it on the receipt. It was done by the previous owner. But I was provided a receipt rebuild was about 2300.
|
|
|
|
|
KENO
Grand Poobah
Joined: June-06-2004 Location: United States Status: Offline Points: 11112 |
Post Options
Thanks(0)
Quote Reply
Posted: July-05-2021 at 12:51pm |
|
If you click on the link below, you'll find an old thread with pretty much everything you need to know about getting to your damper plate and replacing it.
 |
|
|
|
|
Tom85
Newbie
Joined: July-04-2021 Location: Michigan Status: Offline Points: 7 |
Post Options
Thanks(0)
Quote Reply
Posted: August-08-2021 at 12:18pm |
|
Thanks for the help got it all fixed. Not to bad of a repair just a little labor.
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
Tom85 wrote: