80's Ski Supreme / Sierra Supreme

Hey All,

As some of you know from my other topic other topic ,

I recently purchased a 1988 Sierra Supreme. As Supreme is now part of the Correct Craft family, I thought it would be nice to start a Topic for Supreme owner's.

To get us started, I have created an album of Sierra Supreme's. I needed to get an idea of what the decals originally looked like to have them reproduced.

Ski Supreme Samples

With the help from pbrainard and trbenj and others on this forum I have been restoring my Sierra Supreme and have some project photos here.
My Sierra Supreme

I probably overpaid for this boat given all the work that was needed, but in the end I should have a fully restored open bow for around $11k not including my labor.

So far I have done the following:
Replaced the battery and alternator
Replaced the circuit breaker
Replaced the starter relay
Repaired the windshield
Repaired a fiberglass seem in the floor causing a leak
Replaced the tachometer
Replaced the fuel sender
Repacked the rudder port
Replaced faulty switches (accessory switch, bilge switch)
General Tune-Up (Plugs, Wires, Oil)
Repaired a leak in the fiberglass exhaust pipe
Replaced the impeller
Oiled the Teak
Removed over saturated foam

This week I will be working on repairing the interior vinyl including new 3/8" plywood on seats and side skirts, replacing center compartment doors/plywood, replacing the motor box hinges,installing exhaust flaps, and putting the floor back down.

I am working with Mark at Vinyl Approach (www.vinylapproach.com) to recreate the decals so hopefully these will be on file for others in the future.

Thanks to all of the great members at CCF for helping me with my numerous boat projects throughout the years!

Neat touch on the high-back seating

However I would have preferred to see the deck off to tie the floor into the hull proper