Boats For Sale:
carb bowl leaking - repair or replace |
Post Reply 
|
| Author | |
Gary S 
Grand Poobah 
Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: carb bowl leaking - repair or replacePosted: September-05-2020 at 5:09pm |
|
They sell them they just come pre attached to a float bowl
 I have always wondered if you could press down on that plug and peen the ridge around it to tighten it up.....
|
|
 |
|
|
KENO
Grand Poobah
Joined: June-06-2004 Location: United States Status: Offline Points: 10719 |
Post Options
Thanks(1)
Quote Reply
Posted: September-05-2020 at 2:53pm |
I've never found them from Holley or any aftermarket type supplier.
|
|
|
|
|
gun-driver
Grand Poobah
Joined: July-18-2008 Location: Pittsburgh, Pa Status: Offline Points: 4112 |
Post Options
Thanks(1)
Quote Reply
Posted: September-05-2020 at 2:04pm |
|
JB Weld on my ‘85s for years no leaks.
|
|
|
|
|
uncle-buck
Senior Member 
Joined: June-14-2004 Location: United States Status: Offline Points: 318 |
Post Options
Thanks(0)
Quote Reply
Posted: September-05-2020 at 8:42am |
|
Does Holley sell that plug and o-ring?
I searched the site and did not find them. |
|
|
|
|
KENO
Grand Poobah
Joined: June-06-2004 Location: United States Status: Offline Points: 10719 |
Post Options
Thanks(1)
Quote Reply
Posted: September-05-2020 at 6:33am |
|
Here's a link to a previous discussion on those plugs with a picture of what the plug actually looks like. It has an internal O ring that's leaking. A good cleanup job, and about any gas resistant epoxy covering the whole plug area and you should be leak free. Epoxy or replace,............... your choice
|
|
|
|
|
Jonny Quest
Grand Poobah
Joined: August-20-2013 Location: Utah--via Texas Status: Offline Points: 2863 |
Post Options
Thanks(1)
Quote Reply
Posted: September-04-2020 at 11:29pm |
|
Some have repaired with JB Weld with good success. Give it a try.
|
|
|
Current
2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
|
|
|
|
uncle-buck
Senior Member
Joined: June-14-2004 Location: United States Status: Offline Points: 318 |
Post Options
Thanks(0)
Quote Reply
Posted: September-04-2020 at 9:41pm |
|
Just rebuilt an older Holley 4160 carb for a PCM Ford 351W engine.
Mounted it on the engine and ran it on the garden hose. Appears to run great, *but* the secondary bowl is spraying fuel from the place marked in the attached photo. Can it be repaired with solder or is it better to replace it? If replace, who do you recommend buying from? Holley, Summit Racing, eBay or another vendor? Thanks  |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
uncle-buck wrote: