72 correctcraft mustang raw water pump

wally, is your raw water pump driven by a belt or is it crank driven? If possible shoot a pic so we know what pump we are talking about.Yours could be one or the other...............boat dr

Wally, there is good news and bad news. The pump is NLA,but there is a co. that rebuild it to new specs. Give me a call and will point you in the right direction......
Boat Dr 1-318-386-2825

Are you sure that jabsco does not make the pump any longer ? I was looking at a Jabsco catalog the other day and found the one for Holman Moody listed. I will see if I can find it again and give you the part #

Mike

Hello all,
I am working on putting a neglected '70 barracuda back on the water, and need to rebuild the water pump as well.

I contacted Depco based off of the link above and struck gold! Not only did Jim know exactly what he was talking about, they had all of the parts in stock!

To help anyone who might search for this in the future, here is my parts list and pricing from Depco:

Impeller        1210-0001        $16.09
gasket          8614-0000        $8.22
wear plate      8493-0000        $9.70
mechanical seal 96080-0080       $27.81
bearing seal    93000-0090       $6.78
bearing             92600-0070       $32.03
           Total           $100.63
Or the link to their page in the catalogue for the Jabso 11850-0801.Link
My pump is a 11850-80. I'm thinking that the only difference between the two is that the new (-0801) is set up for mounting and belt tensioning off of the end cover, whereas the pump on my HM 302 mounts using the screws for the end cover. What I am getting at that I suspect that they interchangeable (using your old end plate), but at $400 versus $100+ my cheap labor to rebuild, I'll go that route!

Cheers!